path sharing factor and splitter size

2 posts Page 1 of 1
chawki
Posts: 1
Joined: Mon Jul 30, 2018 10:44 am


path sharing factor and splitter size parameters change the result of the high level design (cable route). Can any one explain how to select the right parameters?
gni_support
Posts: 72
Joined: Wed Sep 20, 2017 1:05 pm


Hello!
Depending on the structure of the network, these parameters are used differently.
The path sharing factor parameter is determining the value of the reduction of the cost of a route section that has already been used. If the parameter is lower, more cables are connected to the same route. If this parameter is equal to 1, the cost of the paths will not be reduced.
The splitter size parameter means a splitter that will be used in the nodes with 'FINAL' type.
In this way you can check out for yourself which parameters will best optimize your network.
2 posts Page 1 of 1
ekskluzywne stoły stoły włoskie nowoczesne